Re: I need a hole.
i think you mean you need a hole in your fire wall to run wires through.
the grommet would be the little rubber thing that would seal the hole and hold the wires firm.
what you need to do is get under the hood close to the fire wall and look to see where wires are running into the car. this might save you some drilling. most of the time you will find a hole big enough for you to pass the wires that you need to get through. i am not familiar with your car so i cant give you too much detail on what you need to do but i am sure there is a hole you can pass the wires through.
if not then find a clear spot in the engine bay and drill from the inside of the car out a hole the size of what you need. i would recomend finding the right size grommt for the wire you are using before hand so that you dont end up drilling a hole too big. then insert the grommet and run the wire through. and presto your wires are inside. just hide them well under the carpet and run them to wherever you need them to be.
hope this helps. im sure someone will correct anything wrong that i said or give other ideas as to what you can do
|
