Well that was short lived!!! My car is in the shop again!! Wilbur and I went driving in it after we unloaded the engine and we were getting off the freeway and it up and dies and makes this awful noise! We drove it probably less than a minute to a parking lot to check the oil cuz he thought it sounded like it was low...sure enough it was, the guys that worked on my car must've only put 1qt in cuz it was dry!! So Im laying face down on the wet ground checking to see if there is any oil leaks, cant find any! So we start the car some more and get it to rev at about 2500rpms cuz thats the only time it will make this sound, its still making this awful clunky, grinding noise which we did this for about another minute to try and determine what it was! And all of a sudden hes like "I know this sound, the flywheel is loose!!" The idiots never tightened my flywheel down to where it needed to be!!
I dont think we had it running long enough to do any damage to the crankshaft and whatnot but what do you guys think????
I am definately getting reimbursed for this by them, its bs!! My car is in the Tacoma/Fir Crest area being worked on at a shop because of this and I have to drive Wilburs Elantra, which I dont mind, but I just want my car!!!
