LC2 center console removal....

[95_Accent_GSI]

i know there are the 2 screws behind the cup holders.....is there any others?....or is it like the X3 where its the clips.....what else needs to come off to get it off?

thanks in advance...

[187sks]

If I remember right it's just clips and the 2 screws, but it's been a while.

[95_Accent_GSI]

cool....thanks man

[187sks]

No problem. I'm not 100% sure there are no other screws because it was so long ago so don't just start yanking really hard. lol.

[C-DUBYA]

There are not any more screws but you have to disconnect the harnesses and the heater control cables but that is it.

[03-Accent-03]

2 screws, 2 cables on the driver side and 1 cable behind the glove box. Then a couple clips around the edge and it's off.

[inferredrecords]

http://www.hyundaiperformance.com/forums/topic.php?t=69635

[95_Accent_GSI]

so its the same deal as the X3.....cool....those heater wires were a pain in the @$$ too.....ahwell

[Patrickmann]

1. Remove the glove box
2.Disconnect the intake control mode, mode control, and air mix cable. Two are located under the acceleartion pedal and the other is behind the glove box. All you have to do is push down on the little white part and slide the wire off.
3. Remove those 2 screws where the cup holders are located.
4. After that, remove whole console and disconnect clock, etc..

[95_Accent_GSI]

^^already know what to do...but thanks anyway