accent ecu with beta swap question! plz i need fast help with this! - Hyundai Performance Forums

Wirmpolter · 01-29-2004, 02:13 PM

i want to know what possibilities are open to using a 97 elantra in my 96 accent with piggybacking my accent ecu, what types are out there to use, i know there is apexi's safc, but does anything else work? like msd or anything?
plz i need quick help, i gotta get this part for the weekend if i can.

sk8rpunkn8 · 01-29-2004, 02:58 PM

might want to check the hybrid section.

BlackDevil · 01-29-2004, 09:25 PM

Hey dude, know this is a lil OT, but the other day I got bored..

So I used webtech and made an ECM pinout for both the '98 1.5L sohc accent and the '00 2.0L tib.. I can;t vouch for accuracy, but it is accurate as webtech is.. just all the date on one handy piece.

bizzare · 01-30-2004, 12:24 AM

somebody please make this a sticky, that is basically all the info u need to rewire the harness

8D

Wirmpolter · 01-30-2004, 01:03 AM

ya it is
thats great
make this a sticky
everyone could use this

BlackDevil · 01-30-2004, 02:20 AM

heh.. funny thing is, all this info is avalible on webtech.. I just consolodated it all and made it pretty for easy reference.

If you go to the car of your choice, shop section, fuel system, mfi control system, and then select each sensor. What I did as just look at each sensor's circuit diagram and record where it's pinout (according to webtech) is. The whole circuit diagrams are useful though, to see where every other wire goes, that goes to any said sensor or component. Plus they don't give colors.. just numbers by position in the harness plugs.. so it takes some figuring. But it it shouldn't be too hard for anyone to figure out whatever it is they need to trace down and figure out.

tibby01 · 01-30-2004, 03:08 PM

you guys should check out the new interactive schematics for the new tiburons. they are very cool!!!8D

R.Majarrez · 01-30-2004, 06:33 PM

black devil you are alot of help. you broke it down so everybody can understand it

spikie · 01-31-2004, 01:35 PM

AWSOME!!! so from looking at this you might not really need to change the wiring harness (assuming all plugs on engine side match up) and just rewire a few pins and plug the ecu into the accent harness... there are only about 5 or 6 wires that seem to be in different locations...

BlackDevil · 02-02-2004, 09:32 PM

heh..so it would seem. I can only stress so much that if anything isn't correct though,thenits a problem with webtech (which isn't always known for accuracy when it comes transposing/misplacing info).

If both plugs look exactly the same, they should work in either ecu with a rewireing. I'mnot sure, I haven't lookedat both next to each other in real life. If they aren't the same shape, you would need to do alot of splicing and remebering of what was what.