Hello All I'm in need of where I can findout what the ratios for each gear is in the alfa trannys and the beta tranny's . As some of you know I race my beta swaped accent and I run right on the rev limiter most of the race in second gear( bogs in third). I'm looking to build a tranny with a 1,2, and then like a gear in between 2 and 3. I only use 1 and 2 and reverse so If I can build this and eliminate 3,4,5 . I will machine the gears if I have to but would like to maybe steal from another tranny first of possible. We done this for years on the asphault, but sorry to say know one has come up with gears for Hyundai trannies go figure!!!!!!!!!!!! Lare SSB
Ok question, what is diffeent about the casing of the trannie, like alpha versus beta trannies? is there a different shape or size diference?
__________________
-chris
1.5 litres of fury blowin off very soon at track near you.
-1997 X3 hatch project wanting to go 14.5 @ 95 mph...
...I hope i can do it
I can't remember where I downloaded these, but I've got the disassembly and reassembly videos for the alpha and beta tranny. They're almost identical in apperance. If you can tell me a place that'll host them, I'll put them up for download.
__________________ CERATOGOLD CVVT
CAI with K&N Filter, NGK Iridium IX Spark Plugs, NGK Wire Set, Optima Red Top Battery In Trunk, OBX Underdrive Crank Pulley, Oil Catch Can, Front Strut Bar, Arospeed 2" Lowering Springs, Tiburon 19mm Rear Sway Bar Upgrade, Transmission Oil Cooler, 2 1/4 Custom Catback with Glasspack Free-flowing Muffler
Originally posted by accentric97
[body]
Ok question, what is diffeent about the casing of the trannie, like alpha versus beta trannies? is there a different shape or size diference?
[/body]
I have had them next to each other and they are basically identical in size and mount hole locations. the only differances I found was
1) 1/2 inch thicker were the axles plug in, 1/4 inch on each side.
2) 2 of the mounting locations (front has 2 and the side has 1) have extra bolt holes for the beta mount brackets.
3) Reverse light plug in different location, needs to be modified for Alpha mount to fit.
There may have been some other minor things but I can't remember them if there was. So basically the Beta tranny will swap onto the alpha motor with the alpha mounts and they don't need modified. Now I tried this with the beta motor/trans and the problem was the motor was up against the passenger side wall when using the original 3 alpha tranny mounts and locations.
__________________
Bete 2 engine and transmission (CA Smog legal)
used to have OBX 4-2-1 headers and intake
2 1/4 inch exhaust with a resonator
Rear disc brakes from RD Tiburon
TMW short shifter
APEXi front strut bar
Front and rear GK Tiburon seats
Astrel lip kit
Modified upper and lower grill
Roof spoiler
Painted headlights to match my car
Altezza lights (to be painted)
__________________
-chris
1.5 litres of fury blowin off very soon at track near you.
-1997 X3 hatch project wanting to go 14.5 @ 95 mph...
...I hope i can do it
AutoForums.com is the premier network of enthusiast-owned
enthusiast-operated automotive communities.
We operate more than 100 automotive forums where our users consult peers for shopping information and advice, and share
experiences and opinions as a community.
alfa vs beta tranny ratio
Linear Mode
