cel light:P0108
i recently got a p0108 from my LC's 1.6L ECM
according to the scantool.."Map sensor voltage is too high"
my abnormal stats are -40F intake temperature and a Kpa of 126..which is basically WOT..
it should also mean my car is dumping fuel..but it run's fine,
i checked my map sensor and the voltage on the wires..
the IAT is not functioning properly....because it's reading a -40F
i suspected the -40 as a sensor failure since i tried unplugging the water temp sensor and got a -40 on that also
could it be a bad wiring or a bad map sensor?
i never fiddled with the map wiring..
and i got another code that tell's "bank 1 o2 sensor..high voltage"
HAS ANYONE HAD THIS PROBLEM?
__________________
2001 Beta LC Mods
G4GF 2.0L engine swap..Short ram intake
2.25 Magnaflow Exhaust...OBX Crank pulley
15x6 civic steelies.....Kumho Ecsta AST /205/50/R15's
Front Whiteline Adjustable Sway Bar..Zenn Springs
KSPEC Front & Rear Strut Bars
GT Grant Steering Wheel..Sport Short Shifter
Astrel Side Skirts... KDM Headlights
Stage 3-Spec Clutch..Evofusion Carbonfiber Bonnet.
|
Linear Mode
