wtb lc 1.5L - Hyundai Performance Forums

accent0002 · 05-18-2008, 04:52 PM

looking for running lc 1.5L engine in washington...nw washington would be best but i can travel to tacoma/seattle area, the most im willing to pay is 350 but it would be nice if it was lower than that

Jsharptooth91 · 05-18-2008, 08:16 PM

I have one. You will need to have the head rebuild and checked out! It runs but it leaks oil from the head I think. The block is in great shape. I also have turbo parts and a clutch for the 1.5 as well if you need them. Let me know. my 1.5 is just sitting around. If you need any parts let me know..

accent0002 · 05-18-2008, 10:21 PM

i have a good extra head, how much are you selling it for? is the clutch in good shape?

Jsharptooth91 · 05-18-2008, 11:25 PM

The clutch is in great shape. It only has about 5000 miles on it. I will let it go for 200. Its a spec stage 2 clutch. Im selling it in the FS thread if you wanna check it out. Its the best clutch I've ever owned!
As for the block (maybe 40K on it) I would take 250 for it. The only deal with the block, is that i punched a hole in the oil pan for my oil return line. I have it caped off, so it don't leak.It has a fresh fly wheel on it. So no need to get it resurfaced. Also the block has a new water pump on with about 2k miles on it, if that. New rear main seal as well. New timing belt and tensioner. New thermostat.I can throw in the belts as well. I will throw in the head as well for 300..

I dont think I will be letting go of the starter, alternator, coil pack, and power steering pump. Saving for my beta swap. Do you need them as well?

Do you need the sensors as well?

I can throw in some new plug and used wires that work great. If you need more pix ask or check out my photobucket in my sig....

Heres a shot of the clutch and oil pan...

accent0002 · 05-19-2008, 01:24 AM

k i dont need the clutch...or the head but do you know what the compression was before head problems? i dont need the starter,alternator, coils, or power steering pump...but i do need the sensors on the block if thats ok...where in wa are you btw?

Jsharptooth91 · 05-19-2008, 01:24 PM

Im down in longview/kelso area. Im sorry, i dont know the compression. But it ran fine. Sensor are fine, they can go. They all work ececpt the IAC on the TB. I could meet you some where if its just the block. Its not that heavy. Do you want the flywheel as well?

accent0002 · 05-19-2008, 01:38 PM

yeah but im going to wait a little bit and see if i can find one a little closer

Jsharptooth91 · 05-19-2008, 02:56 PM

I could meet you half way. I can throw in all the belts, plugs, wires, and it even has a new head gasket you may be able to use. Also have new head bolts as well.

accent0002 · 05-20-2008, 03:17 AM

i may be interested if this deal doesnt go through with a beta im trying to get