New gauge pod with oil psi gauge installed

[Jsharptooth91]

Here are some pix of my oil pressure gauge that installed over the week.
The only thing that i am pissed off about is, that I fiberglassed my piller with a gauge pod in it. When I went to install it, it kinda broke. Now i have a little indent when it broke.... Its small, but i spent a lot of time on it... I think going the route where i dont care about looks that much anymore.....

PS.. the bottom hole is reserved for boost gauge....

Any ways here are some pix of it.... More pix in my photobucket if you wanna check them out too.....

[187sks]

Cool. Looks pretty good.

[RTPScoupe]

looks sweet! Did you put blue leds in your gauge cluster? How did you do this?

[Jsharptooth91]

Originally Posted by RTPScoupe

looks sweet! Did you put blue leds in your gauge cluster? How did you do this?

Yes they are just led in the gauge.. I bought them here. You can do any color you want.. Blue is just may favorite color..
eBay Motors: 10 x 194 Blue LED Wedge Inverted Side Light Bulbs 12V (item 200208925002 end time Mar-21-08 13:23:57 PDT)

[Misfits]

how did you get the back light to be blue?

[Jsharptooth91]

Originally Posted by Misfits

how did you get the back light to be blue?

The leds from the above post.^^^^^^^^

[Misfits]

easy to install?

[Jsharptooth91]

Yea it pretty easy... Just have to remove the gauge cluster and pop out the old bulbs and put in the leds. Just when you do this, you need to keep the bulb holders.(don't know technical term)...

[DarcyWGeorge]

Where did you get you lip kit at??

[Jsharptooth91]

Originally Posted by DarcyWGeorge

Where did you get you lip kit at??

I bought it off ebay. It was about 5-6yrs ago. They dont make they kit anymore, and they are very very hard to find!