Hyundai Forum: Hyundai Performance Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
scanner is pulling codes P0017 - Permanent at one point it was showing code P0365 and p0335.
We replaced Camshaft position sensors and crankshaft sensor. we also changed out VVT and vehicle wont start.
We followed a video on Youtube and tested position sensor connecter and showing voltage on both as 5.3 volts. Crankshaft voltage is 0 with car in on position.
the vehicle will not start.
Question is. What can we do to figure out this issue and get the car to start?

I uploaded a picture of the code currently showing. I tried to upload a video of the car but this forum wouldnt allow me to add it.
 

Attachments

1 - 1 of 1 Posts
Top