Hyundai Forum: Hyundai Performance Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hello, I realize I am a noob here and I'd like to say thanks in advance for any help or advice.

I have some questions reguarding putting a Mitsubishi evo 8 (4g63 7-bolt) head on a hyundai 4g64 (g4js I believe) block. HAs amyone on this site had experience with this? I know that the evo community has used this block with this head without problems to increase the displacement from 2.0L to 2.4L, or the destroker 2.1. I know this is popular for turbo aplications in evos, but has anyone used this combination in a naturally aspirated build?

-Thanks
 

·
Registered
Joined
·
492 Posts
i was going to do this but upon teardown of my block i found the number 1 piston broken and the sleeve in cylinder 1 cracked. i was going to turbo it but the busted block scrapped those plans. some info for you on this setup on project z g forums the hyundai g4cs 2.4 block lines up the oil passages with the head perfect with no mods but na its up in the 12:1 compression ratio with stock pistons and dohc head
 
1 - 2 of 2 Posts
Top