Hyundai Forum: Hyundai Performance Forum banner

1 - 1 of 1 Posts

·
Banned
Joined
·
1,112 Posts
Discussion Starter · #1 ·
ok last night i replaced the left driver side ball joint with a new one-the problem i have is that i dont know what the finished job is supposed to look like and idk how far the screw or wutever has to go through the tightning clamp....i bounced the car and nothing moved but i think when i go over bumps there is still some slight noise like a bump... i have to do the other side later but was just wondering if i did the job right,cuz i noticed that the ball joint had a edge in the middle of the screw/joint that gets clamped , does that have to be above the clamp or wut cuz i just put the axle hub thing back on the ball joint tightned the clamp and that was it plz help...

THIS IS IN A ESCORT GT 1.8L!!!!!!!! should be about the same as any car...

i own a accent though :)
 
1 - 1 of 1 Posts
Top