Hyundai Forum: Hyundai Performance Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter · #1 ·
Whenever I go over a bump or small crack in the road, i get a banging noise from both rear wheels. It was only from one wheel at first, then i replaced the shocks and the noise was gone for about a month. But then, all at once, it came back, but now from both rear wheels. Has anyone else had this problem?? I'm about to take the shocks back (lifetime warranty) and buy new springs. The noise is soo annoying!


<hr noshade width=60% size=1 align=left>I own a loud car.
 

·
Registered
Joined
·
21,319 Posts
Is your car lowered?

If so and you are buying cheap shocks you are blowing them and the noise would be from them bottoming out. If this is the case get some kyb's <img src=/images/forums/snitz/thumbup.gif width=25 height=18 border=0>


<hr width=60% noshade size=1 align=left><font color="red" size="4">Hyu</font><font color="orange" size="4">ndai</font><font color="yellow" size="4">Tun</font><font color="green" size="4">er =</font><font color="blue" size="4"> t3h</font><font color="purple" size="4"> ghey</font>
 

·
Registered
Joined
·
132 Posts
Discussion Starter · #3 ·
No, my car rides on the original springs. And the shocks are monroe sensatracs.


<hr width=60% noshade size=1 align=left>I own a loud car.
 

·
Registered
Joined
·
21,319 Posts
Well quit doing 50mph over speed bumps.<img src=/images/forums/snitz/wink.gif width=15 height=15 border=0>

Seriously I don't know then.<img src=/images/forums/snitz/disapprove.gif width=15 height=15 border=0>


<hr width=60% noshade size=1 align=left><font color="red" size="4">Hyu</font><font color="orange" size="4">ndai</font><font color="yellow" size="4">Tun</font><font color="green" size="4">er =</font><font color="blue" size="4"> t3h</font><font color="purple" size="4"> ghey</font>
 

·
Registered
Joined
·
132 Posts
Discussion Starter · #5 ·
I found out why i have the noises... I was looking up recalls and technical service bulletins on alldata, and it said that the factory bushings on the rear shocks are too soft, and all new shocks should have the harder bushings, the "new" shocks I go must've been sitting in the warehouse for a while. I'll probably just go with polyurethane <img src=/images/forums/snitz/oogle.gif width=15 height=15 border=0>
 
1 - 5 of 5 Posts
Top