Hyundai Forum: Hyundai Performance Forum banner

Bending PVC pipe...

5K views 17 replies 9 participants last post by  talhamugha 
#1 ·
HOW DO U DO IT. im guessing with some source of heat... hmmm but howwwww!:mad:
 
Discussion starter · #3 ·
hmmm yeah cos im making a intake pipe out of pvc... and i guess will still work the same using the corner joiners... would be better if it were bent though... better flow?
 
Discussion starter · #15 ·
i could spend $150 on an intake... but that would cost $150... thats the point... but no im not going to use pvc piping anymore.... but i will be using something and modifying it to fit myself... cos it wont cost much :)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top