If you are using the 1.5 tranny then you can use your stock axl's. Also you can use your stock motor mounts on the tranny. You will have to cut a small section out of the beta block to use the 1.5 tranny because of the slave cylinder and were it bolts up to on the tranny.
beta swap driveshaft with accent tranny???
ok i am geting ready to swap and almost go all my parts,now i will be using my accent 1.5L tranny and i just want to know do i have to change my driveshaft or can i use my stock 1.5 one or do i need 1.6 ones ???
1 - 8 of 8 Posts
am i better off geting driveshafts off a 1.6L accent or is it the same as the 1.5L ones???
I don't know if they are the same , just use the 1.5 axl's since you already have them.
ok, but dous any one here havea beta swap lc or lc2 with 1.6 drive shafts???
The shafts are exactly the same thickness so there would be no point unless your vcs are stuffed anyhow.
but are they the same length???Originally posted by BetA_X3
[body]
The shafts are exactly the same thickness so there would be no point unless your vcs are stuffed anyhow.
[/body]
omg he said they will work... so just listen to him and go 'ok' and use them. :ermm:
1 - 8 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hyundai Forum: Hyundai Performance Forum
A forum community dedicated to all Hyundai models owners and enthusiasts. Come join the discussion about modifications, classifieds, troubleshooting, maintenance, reviews, and more for your favorite models!
Full Forum Listing
