Hyundai Forum: Hyundai Performance Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I just installed a clutch and the slave cylinder is not working right. well the shift fork lever is about 15 degrees from the transmission stop, so the slave cylinder is extending, but the pressure plate force is not pushing the fluid out of the slave cylinder. since the lever only goes on one way, how can i fix it, adn what is the problem?
 

·
Registered
Joined
·
6 Posts
I'm having the same problem right now as a matter of fact. I have no clutch pedal travel what so ever. I did figure out if I manually push the slave cylinder back into it's bore then the pedal travels like normal then gets stuck and won't work again until I push my slave cyclinder in again.

Dennis....
 
1 - 2 of 2 Posts
Top