Hyundai Forum: Hyundai Performance Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
6,330 Posts
that material is made from soft rubber that can deform at high speeds..

it's better to go with hard plastic or polyfiber..

but then not much companies made GF kit's for LC's..
 

·
Registered
Joined
·
354 Posts
Discussion Starter · #3 ·
what could i use thats cheap to make a lip then? they are kinda hard to find and if you find one theyre over 100(which is to much)
{yea i wrote this when i was high so um i dont know if its wrote understandibilityity}
 

·
Registered
Joined
·
332 Posts
go with like universal front splitters from like carboncreations.com or extremedimensions.com i got a set for my x3 but i had to trim a little for proper fit and i have had alot of people wanting to buy mine
 

·
Registered
Joined
·
1,447 Posts
TAK82 said:
that material is made from soft rubber that can deform at high speeds..

it's better to go with hard plastic or polyfiber..

but then not much companies made GF kit's for LC's..
so what if it deforms at high speeds it won't break off if he hits a bump.

i think it would be fine the curvature of it should stiffen it up enough to work.
 

·
Registered
Joined
·
6,330 Posts
i think we need to get psc to start cranking up astrel kit's again..

if only we had about 15 people who would be interested in a ground effect's kit..

I've seen many good GF kit's for the LC..

PSC Talon Kit...Example:Bentley
Sick division Kit..ThasilvaL
Astrel Kit..me, drerob,
 

·
Registered
Joined
·
228 Posts
I made one for my LC. I got a rubber air dam from a new Buick Lucerne and cut it to size. It worked well and looks good.

 
1 - 9 of 9 Posts
Top