Hyundai Forum: Hyundai Performance Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
424 Posts
Discussion Starter #1
I know this has been talked about before on some of the .... other .... forums. But what do some of you guys think about getting your Tiburon or other Hyundai car Extrude Honed?
Any comments ... pros or cons?
 

·
Registered
Joined
·
14 Posts
get it done! the flow on the tiburon beta head has poor air flow. any improvment to the manfold or head will yeald better reslult with outher upgrades.



rally cross is the only way to go
 

·
Registered
Joined
·
424 Posts
Discussion Starter #3
Well do you think any gains seen from the Extrude Hone process would justify the cost to have it done?
 

·
Registered
Joined
·
8,316 Posts
It depends on if you eventually plan on boosting or not. If you're planning on leaving the Tib N/A, then it probably won't offset the cost.

--------------------------------------------
I drive a slow car.
0 to 60 in 11 seconds (look out!)
 

·
Registered
Joined
·
14 Posts
i say you will feel it you have 15% better flowing head at worst. and youll always have that power on hand not like nos or the unrelible turbo or supercharges that have for our car. get it done it wont hurt and it will improve the nasty flow of the heads the fore the us market cars. get the work done



rally cross is the only way to go
 

·
Registered
Joined
·
424 Posts
Discussion Starter #6
well to be honest with you i have been thinking about it. BUT if i do do it i will do it to a different head. as i am planning on buying a second beta motor to build.
;)
i dont wanna ruin the one i have.
 
1 - 6 of 6 Posts
Top