Hyundai Forum: Hyundai Performance Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
does anyone know how hard it is to take the front hub off the spindle to replace the bearing.I know it has to be pressed in/out by a machine shop.also how hard is it to replace the outer tie rod ends
 

·
Registered
Joined
·
9,188 Posts
I would just replace the spindle ass'y if it is pressed in. I had a hell of a time doing my buddy's 2000 Tib.... :hmmm:
 

·
Registered
Joined
·
897 Posts
all I know is that its basic to remove everythign else like the tie rods, axle etc.. but getting the bearing out you need a press.
 
1 - 4 of 4 Posts
Top