Hyundai Forum: Hyundai Performance Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
I just installed my E-Manage Blue into my MAP based Hyundai Tiburon with a 2.0L Beta engine and turbo. I'm having trouble with the RPM. Everything in the E-Manage works perfectly fine except for the RPM signal. It always reads zero. I connected the brown wire in one of the crank posisition sensors. This method worked fine with the SMT-6 but the E-Manage cannot read the RPM.

Any inputs on this one? I'm completely lost :(
 

·
Registered
Joined
·
3,276 Posts
Check the emanage jumpers theres a emanage thread that says what they should be set at. Im almost positive pin #47 is the rpm and its a white wire but check the hybrid section under beta ecu swap wiring or something, i posted a wiring diagram of the ecu up. If yours is a beta one from like 97-01 that is.
 

·
Registered
Joined
·
3,276 Posts
I have a 98 accent and it had the seimens ecu, i swapped it to the beta ecu it was plug and play.
 
1 - 6 of 6 Posts
Top