Hyundai Forum: Hyundai Performance Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys, A friends 2015 ix35 G4nc engine failed.
I’ve managed to find a low km 2018 i30 G4nc engine and installed it. It starts after turning over for 10secs. Runs and revs fine. Comes up with a engine fault. Cam sensor a and b range/failure.
I’ve found the sensors reluctor wheel on the i30 engine is different to the ix35.

Any one else played with the cams on G4nc engines?
Local Hyundai dealer said they can’t change the programming?
I’m thinking if the cams reluctor is exchangeable, I might change them over?
 

·
Registered
Joined
·
1 Posts
Hi, I was ready you problem with the long cranking on the ix35 due to the cam pick up points being different, I’m currently in the same situation as you, how did you go about fixing the problem? Thanks
 
1 - 2 of 2 Posts
Top