mod

753 Views 1 Reply 2 Participants Last post by danwagon, Apr 5, 2006

metalizer

Discussion Starter · Apr 5, 2006

hey fellas, i have a 2003, 4cyl tiburon, and im going to beef her up
here is what im hoping to do

install a big bore throttle body,
and a short ram air intake

thats it for now

what im asking is what is the best diameter size to go with for the big bore throttle body, 52.5mm, or up to 65mm?

and second, what ram intake is the best for me, AEM, INJEN, or anything, im not looking to spend a hell of alot of $$ but something with roar and gritt.
also could i use a 6 cyl ram intake instead, with no mods, just rip apart and bolt on, is it all good.

if you have any pointers or tips regarding this PLEASE HIT ME UP... MUCH APPRECIATED, any input is killer
thanxs

and tear it up

Save

1 - 2 of 2 Posts

danwagon

· #2 · Apr 5, 2006

ok i have a 99 elantra wagon and it pulls good with the following done-
bbtb=58mm
cold air intake(off ebay)
no ac
no exuast after the cat
and i did the cluch mod(i highly recomend it)
i am going to put my 58mm cleaned intake man back on the car when i get the gasget set in.

i dont know if that will help you but maybe it will good luck.

Save

1 - 2 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month