Hyundai Forum: Hyundai Performance Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
1,165 Posts
Discussion Starter · #1 · (Edited)
Here are some pix of my oil pressure gauge that installed over the week.
The only thing that i am pissed off about is, that I fiberglassed my piller with a gauge pod in it. When I went to install it, it kinda broke. Now i have a little indent when it broke...:mad::mad:. Its small, but i spent a lot of time on it... I think going the route where i dont care about looks that much anymore.....

PS.. the bottom hole is reserved for boost gauge....:):)

Any ways here are some pix of it.... More pix in my photobucket if you wanna check them out too.....













 

·
Registered
Joined
·
845 Posts
looks sweet! Did you put blue leds in your gauge cluster? How did you do this?
 

·
Registered
Joined
·
1,165 Posts
Discussion Starter · #4 ·

·
Registered
Joined
·
1,165 Posts
Discussion Starter · #8 ·
Yea it pretty easy... Just have to remove the gauge cluster and pop out the old bulbs and put in the leds. Just when you do this, you need to keep the bulb holders.(don't know technical term)...
 
1 - 12 of 12 Posts
Top