Hyundai Forum: Hyundai Performance Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,964 Posts
Discussion Starter #1
ok, first of all i intend to check results using a wideband, but i was hoping someone with experience and common sense and brains et al could wake me up and save me some time.

first im assuming 2 things, 1. stock 1.6L alpha injectors are 190cc and 2. stock map sensor reads up to 1.5 bar max

based on this, i believe that swapping in kspec's 2.5 bar map sensor (which would then output less voltage) and 290cc injectors (higher flow) would nearly balance out (give or take about 27cc)

2.5 x
___ = ---
1.5 190

190(2.5)/1.5=~327-290=27

so some correction would be necessary


now this is the part where you tell me im smoking crack and "that's just not how it works buddy"

thanks :)
 

·
Registered
Joined
·
158 Posts
RBUECKER As my mother said never assume it makes an ass of u & me. Check HMAservice.com. They have the specs you need. Then you can do your math. And then you can tell the rest of us.
 

·
Registered
Joined
·
842 Posts
love the math... any formula's for a 2.5" MAF to 3bar MAP conversion? ;] just kidding. everybody will always argue about the numbers, so just try it out and tell everybody you were right later on. :lol:
 
1 - 4 of 4 Posts
Top