Hyundai Forum: Hyundai Performance Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
284 Posts
Discussion Starter #1
i did a search and couldnt find anything.. so the question i have is over the winter i am going to overhaul my engine and tranny and completly rebuild them (this is on a 00 elantra).. i am lookin on the HP store and they say you need a new ecu.. does anyone know where i can get a new ecu or what i can do to support these.. b/c i would either like to get them or the 282's on kspec http://www.kspec.com/list.php?ac_id=85&ai_id=1419. second is would the 83mm pistons http://www.kspec.com/list.php?ac_id=85&ai_id=1417 be good to support the cams. I already have the intake and exhaust taken care of along w/ the lightweight pullys.. i have bought some products from level 10 already like the torque converter and the hydrosystem and plan on finishing up the tranny w/ there products. any help would be appreciated before we start to purchase everything. thanks

[Edited by h2opunk182 on Oct 26, 2005 4:34 PM]

[Edited by h2opunk182 on Oct 26, 2005 4:35 PM]
 

·
Registered
Joined
·
3,943 Posts
any decent piggyback unit should be able to accomodate even the extreme mods youre planning on. the only thing is that your rev limit is still set at 6500, if you want to go higher standalone is your option.
 

·
Registered
Joined
·
508 Posts
^^ some piggyback let you move your revlimeter hire!!
 

·
Registered
Joined
·
284 Posts
Discussion Starter #4
alright well im definity going piggy back.. so another question is which one.. there is so many to choose from http://www.andysautosport.com/.. i was thinking the greddy emanage, but then there is the hks..
 

·
Registered
Joined
·
2,164 Posts
83mm pistons are to large IMO that leaves way to little room for error

and i would go with a SMT6 as ive heard emanage is still in a iffy stage with the beta as not many people have ran it yet

[Edited by faithofadragon on Oct 27, 2005 5:19 AM]
 
1 - 5 of 5 Posts
Top