Hyundai Forum: Hyundai Performance Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
390 Posts
Discussion Starter · #1 ·
Well with the advise of someone I emailed [email protected] but apparantly the email address is unknown?

Does anyone here have any expertese on Cuda Design?

A few more questions.
For upgraded Brakes, are the front rotors the same as the back? Who makes a cross-drilled/slotted rotor that will not rust (Brembo, AEM, Stillen, Powerlsot, ect)?
Whats the best pads out there?

Last one of the day.........are there all 4 suspension braces avaliable? Front and rear strut tower bars and front and rear lower say bars?


<hr noshade width=60% size=1 align=left>
 

·
Registered
Joined
·
1,415 Posts
[email protected] <img src=/images/forums/snitz/thumbup.gif width=25 height=18 border=0>

Brad's SN is: bsutton760

<hr width=60% noshade size=1 align=left><b>Don't Look Through The Glass Without Looking at Your Reflection</b>

HP.com #1 Pimp
 

·
Registered
Joined
·
1,415 Posts
as for anything Body wise, you wanna talk to 2000LoandShow - AKA JOSH.... his SN is OceanSurfer1977 and lemme get his email for ya. Here is his email: [email protected]
Tell him Drew sent ya. <img src=/images/forums/snitz/tongue.gif width=15 height=15 border=0>


As for the Brace thing, I'm going to step out on a limb and say yes. <img src=/images/forums/snitz/approve.gif width=15 height=15 border=0>

I don't know much about brakes... sorry <img src=/images/forums/snitz/disapprove.gif width=15 height=15 border=0>

<hr width=60% noshade size=1 align=left><b>Don't Look Through The Glass Without Looking at Your Reflection</b>

HP.com #1 Pimp
 

·
Registered
Joined
·
14,259 Posts
powerslot
www.sharkracing.com

front, rear, rear lower. contact www.hdkautosport.com and sharkracing.


<hr width=60% noshade size=1 align=left>my car is yellow. [email protected]
you should never underestimate
the predictability of stupidity.
 

·
Registered
Joined
·
1,415 Posts
Thanks Rudy <img src=/images/forums/snitz/thumbup.gif width=25 height=18 border=0>
I was about to post some links... haha <img src=/images/forums/snitz/angel.gif width=25 height=20 border=0>


<hr width=60% noshade size=1 align=left><b>Don't Look Through The Glass Without Looking at Your Reflection</b>

HP.com #1 Pimp
 

·
Registered
Joined
·
390 Posts
Discussion Starter · #6 ·
Well, thanks for the names again.

The biggest question that is eluding me is the Cuda taillights, where the hell can I get a set? They are not the same inside desigan as the Shark or APC tails.

The second, I would have to talk to brad about the Cuda body items.

Third, do the powerslot rotors rust at all?
The ones AEM sells do not corrode at all, they have a zinc alloy mix that keeps them from tarnishing.
Most importantly, are the front rotors and back rotors interchangable? Are they the same size?


<hr width=60% noshade size=1 align=left>
 
1 - 6 of 6 Posts
Top