Hyundai Forum: Hyundai Performance Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
390 Posts
Discussion Starter · #1 ·
Well with the advise of someone I emailed [email protected] but apparantly the email address is unknown?

Does anyone here have any expertese on Cuda Design?

A few more questions.
For upgraded Brakes, are the front rotors the same as the back? Who makes a cross-drilled/slotted rotor that will not rust (Brembo, AEM, Stillen, Powerlsot, ect)?
Whats the best pads out there?

Last one of the day.........are there all 4 suspension braces avaliable? Front and rear strut tower bars and front and rear lower say bars?


<hr noshade width=60% size=1 align=left>
 

·
Registered
Joined
·
390 Posts
Discussion Starter · #6 ·
Well, thanks for the names again.

The biggest question that is eluding me is the Cuda taillights, where the hell can I get a set? They are not the same inside desigan as the Shark or APC tails.

The second, I would have to talk to brad about the Cuda body items.

Third, do the powerslot rotors rust at all?
The ones AEM sells do not corrode at all, they have a zinc alloy mix that keeps them from tarnishing.
Most importantly, are the front rotors and back rotors interchangable? Are they the same size?


<hr width=60% noshade size=1 align=left>
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top