Hyundai Forum: Hyundai Performance Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Hello i am the owner of 98 tiburon fx and i am currently workin on removing the tranny i have most everything disconected except the halfshaftsMy main problem is removing the driveshaft nut on boths sides. Had to go to autozone and find a big enough socket to fit but still can't break it loose. was wonder if anyone had any tip and instructures for further work on disconecting the halfshafts. ANY ADVICE WILL HELP
 

·
Registered
Joined
·
11 Posts
Discussion Starter #3
yeah i took the the pins off both of them and used the breaker bar. put the tire back on so the brakes wouldn't turn its soaking in wd40 now
 

·
Registered
Joined
·
11 Posts
Discussion Starter #4
alright after workin in the garage for a little while i managed to get both drive shaft nuts off. after that i was told the next step is to pull the axle "halfshaft" out i tired that and no matter what i did i could only get it to come out a half and inch then it wouldn't budge. Does anyone know what else i have to remove or lossen to fully remove the halfshaft. thank u very much all infromation to this point has been very helpful.
 
1 - 6 of 6 Posts
Top