Hyundai Forum: Hyundai Performance Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a 1999 Elantra and the int. wiper control and park does not work. The slow and fast speeds work fine. I have checked fuses and motor works fine (connected up spare working motor, and verified it worked, only on slow and fast wiper speeds as well).

According to the schematics the ETACM is responsible for the int wiper, timing control, and auto parking. I need to first get to the module (in back of ashtray/radio), check the power to it, and and the ground, and possibly replace it.

My question is how do I best dissemble the under part of the dash/center console to get to it? How much should I expect to pay for a new one? Any other concerns I should be aware of?

Thank you, Todd
 

·
Registered
Joined
·
174 Posts
you need to take a flat head screw driver and place in between the shifter cover and pop it out. Then you need to take a phillips screw driver and unscrew the two screws, one behind the dimmer switch ( need to pop that out as well) and one at the bottom of the center console. You also need to unhook the ac wire thats located under the dash near the gas pedal and it should pop right out
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Etacm

you need to take a flat head screw driver and place in between the shifter cover and pop it out. Then you need to take a phillips screw driver and unscrew the two screws, one behind the dimmer switch ( need to pop that out as well) and one at the bottom of the center console. You also need to unhook the ac wire thats located under the dash near the gas pedal and it should pop right out
Thanks Dragonis. Do you know which module is the ETACM, the upper or lower module in back of the ash tray?
 
1 - 4 of 4 Posts
Top