Hyundai Forum: Hyundai Performance Forum banner

Seat Bolt Pattern and Airbag Problem

712 Views 1 Reply 2 Participants Last post by  crnrkiller
So, the little seat the car came was killing my back and I got a new one.

Little did I know it didn't come with reclining mechanism, so I took my original one apart and bolted on the top and bottom to the frame of the seat.

Well, it's slightly off-center and I'm ready to do it right. I need to buy the frame part though, and I don't see it for the LC2. Just wondering, does anyone know if the seat bolt pattern (where the seat frame/slides bolt to the car's frame) is the same for the Tiburon as the Accent?

Also, how do I turn the airbag thing off now that that wire isn't connected? Thanks again, -Stu
1 - 2 of 2 Posts
i know the accent and the tiburons frames do not match up if that helps any.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.