Hyundai Forum: Hyundai Performance Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
423 Posts
Discussion Starter #1
I read a few posts on how to put a tach on an 1999 Accent, but I couldn't get the damn thing to work. So could someone possibly tell me how to install it on a 1999 accent without a stock tach. I just cant seem to find the wire wit the signal from the coils. Thanks
 

·
Registered
Joined
·
230 Posts
You cant get it from the coil, you have to splice it from your ecu, but be careful you dont mangle your wiring harness. The ECU is located below the steering wheel. Look at a Haynes or Chilton's manual for a 95-99 accent and look for RPM OUT signal that goes to the transmission...Its an all white wire but I can't remember which Pin it is on the ECU. Maybe someone else can identify it for you.
 

·
Registered
Joined
·
26 Posts
It's wire number six from the ECU. And like leftside ryder said it's a solid white wire.

Later

http://www.viggdesigns.com

H.A.T.E.
 

·
Registered
Joined
·
423 Posts
Discussion Starter #5
I pulled off the ecu clip and it doesnt have the #'s marked on it as to what pin num it is. any other Ideas. Maybe Ill just try chiltons, or does neone know where I can find a wiring schamatic of my car on the net?
 

·
Registered
Joined
·
272 Posts
Hi there.

Follow my instructions for doing the swap on my website.
http://www.geocities.com/hyundaixl2000
and click on the D-I-Y button.

Good luck!

http://www.geocities.com/hyundaixl2000
 
1 - 6 of 6 Posts
Top