Hyundai Forum: Hyundai Performance Forum banner
1 - 1 of 1 Posts

53 Posts
Discussion Starter · #1 ·
Hey Guys,
I am getting an oil pressure gauge and was pricing out the senders. Looks like I'm going to tap into the existing hole for my oil pressure switch. The sender I'm looking at also has outputs to trigger the oil light, should the pressure dip too low. (which saves me from having to do a T fitting installation)

However, I'd like to know the hole size and thread pitch for that sensor, so I can order the right sender.

Anyone know?


<hr noshade width=60% size=1 align=left>My Car Page:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.