Hyundai Forum: Hyundai Performance Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter #1
ok....i did that free cam sprocket mod that was in the NA forum. worked great....well after a couple weeks i decided to put it back to normal. i got it all messed up i just can't find any of my marks i had or nothin. how do i go about fixing this?
 

·
Registered
Joined
·
81 Posts
Discussion Starter #3
i can't see the crank gear though.....i know it has marks on it.....but do i gotta take all kinds of crap apart to get to it?
 

·
Registered
Joined
·
6,117 Posts
Take out all 4 plugs. Remove the timing belt. Stick a long rod down the plug hole nearest the crank. Turn the engine over by hand until the rods comes up as high as it will go. This is TDC on the #1 cylinder. Use a service manual or webtech to align your cams to the proper position with the #1 cylinder at TDC. Then re-install the timing belt and plugs.
 
1 - 4 of 4 Posts
Top