Hyundai Forum: Hyundai Performance Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6,330 Posts
Discussion Starter · #1 ·
scoupe clutch came in, 4 hours later, it's installed, i used my original TOB since the scoupe one didn't fit,

the clutch pedal is alot softer,

but i now have another problem or 2, my threaded end on my driver side axle is crooked since i hammered it to extract it out, so i can't put the 32mm nut back on..****..

another problem is my car start's and idles weird, it sound's like it's drunk,
not exactly a misfire, it's like a fast drdrdrdrdrdrdrdrdrdrdrdr, it rev's slow and for some reason, my speedo needle come's up when i'm not in gear , given the fact that i have no gear lube in my gearbox, since i thought it wouldn't hurt since my axle's aren't spinning, my cel is flashin too..

i had the same idle problem when my map signal wire's were severed during my safc install

i re-installed everything correctly, starter, shifter bracket, mounts, harnesse's
 

·
Registered
Joined
·
6,330 Posts
Discussion Starter · #2 ·
****, i answered my own question

one of the coil pack connectors broke,

took a connector from a 1.5L and soldered it, good as new,

all it need's now is a new axle.
 
1 - 3 of 3 Posts
Top