Hyundai Forum: Hyundai Performance Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Need the engine, and whatever else is REQUIRED to do the swap, I beleive only the beta engine is required?

anyways, drop me an e-mail at [email protected]

thanks.

[Edited by vect0r on Oct 26, 2005 9:41 PM]
 

·
Registered
Joined
·
1,054 Posts
You have a GT, so you could get away with using the Accent ECU and wirirng. You might have to make a few modifications though, not terribly sure. Use the search and check the hybrid section.
 

·
Registered
Joined
·
582 Posts
dam if i would have known that i would have kept my 97 GT wiring/ecu:dead:
 

·
Registered
Joined
·
1,903 Posts
you'll need the engine and possibly a tranny and new crossmember.. check to see if the front engine mount is on the engine or the tranny.. the earlier ones had it on the engine which means you need a new tranny from a 98-99 accent as well as the cross member.. as for the swap is pretty easy in a GT.. use a scoupe turbo clutch to mount the accent tranny to the engine.. and you have to redo one engine mount.. also the wiring from the GT is almost perfect for the 2.0L... You have to extend the wires for the O2 sensor and the ISA other then that everything else hooks up fine and you can run it on the gt ecu with an engine light but it does run good...

Good luck with the swap!
 
1 - 4 of 4 Posts
Top